Rack Mount RJ45 SPD 24 Channels Lightning Protection Cat5e Network Surge Suppressor
Model: SN-RJ45/24
INSTALLATION AND MAINTENANCE
a) The SPD should be connected in series between the protected device and the signal/power transmission channel.
b) The input terminal (IN) of the SPD should connect to the signal/power transmission channel, and the output terminal (OUT) of the SPD should connect to the protected device.
c) Connect earthing wire of the SPD to earthing bus-bar of the lightning protection system of the room or building.
No special duty needs to be carried out for maintenance. When problem arises and the SPD is suspected, check the system with SPD taken out of circuit. Should system recover, the SPD shall be regarded as a damaged unit and must be replaced immediately.
Model: SN-RJ45/24
| Thank you for choosing Cat5 Surge Protector SN-RJ45/24. The model is designed to protect high-speed communication network 24 channels from lightning over-voltage, transient over-voltage and static discharge. The protector implements multi-level protection circuit with advanced manufacturing process, and has excellent performance on discharge current, limiting voltage, response time, stability and over-all reliability. | |
| FEATURES: Multi. Protection circuits, Gas-Tube+ TVS technology Dual protection in Common module and different module TVS array technology, low capacitance Multi-Strike Capability | |
| TECHNICAL PARAMETER: | |
| Model | SN-RJ45/24 |
| Electrical Parameter | |
| Max. continuous operating voltage Uc | 6V |
| Nominal discharge current(8/20µs)In | 2.5kA |
| Max. discharge current (8/20µs)Imax | 5kA |
| Limiting voltage (10/700µs) Up | |
| Line-line | 25V |
| Line-ground | 500V |
| Adapt transmission rate | 100Mbps |
| Insertion loss Ae | 0.5dB |
| Protection line | 1/2 3/6 |
| Response time Ta | 1ns |
| Interface form | 24 channels RJ45 |
| Mechanical characteristics | |
| Dimension | 44×106×482mm |
| Weight per unit | 2500g |
| IP Code | IP20 |
| Working conditions | Temperature: -40 to 80ºC, Relative humidity: ≤95% |
| Standards Compliance | CE, FCC, RoHS,ISO9001 |
INSTALLATION AND MAINTENANCE
a) The SPD should be connected in series between the protected device and the signal/power transmission channel.
b) The input terminal (IN) of the SPD should connect to the signal/power transmission channel, and the output terminal (OUT) of the SPD should connect to the protected device.
c) Connect earthing wire of the SPD to earthing bus-bar of the lightning protection system of the room or building.
No special duty needs to be carried out for maintenance. When problem arises and the SPD is suspected, check the system with SPD taken out of circuit. Should system recover, the SPD shall be regarded as a damaged unit and must be replaced immediately.